1.Production of cone crusher

Production of cone crusher is related to the methods, feeding fragmentation, fragmentation of discharge size, physical and mechanical properties of the ore, temperature and so on, vary widely, factory Production is given under specified conditions schematic throughput.

Symons Cone Crusher

2.Replacing of cone crusher wall

Cone crusher cone wall is fixed to the body with a conical head, zinc alloy casting between the two, after a new installation or Replacing of a new cone crusher wall work 6-8 hours, you should check their retention, should be immediately found loose fastening

3.Introduction of Spring

When the action of the spring into the cone crusher was not crushed when the cone crusher is not protected from being damaged, the crushing force of the spring pressure and adapted to the crusher, the crusher during normal operation of the spring is not moving, only in the crushing chamber fall when iron overload makes crusher lift support sleeve spring is compressed phenomenon.